local read magnetic flap level gauge

1,used wherever fluid level has to be monitory, indicated 2,Switch & analoge signal output 3,easy to install, local read

Introduction

UHF magnetic flap level gauge is design according to Q/XY001,-2009 standard, and in compliance with HG/T 2742-1995, which not only upgrade product to traditional glass tube, glass flap level Gauge and also possess the function that could not bring out, eg, Switch and analog output. UHF series is used wherever fluid level,Has to be monitory, indicated in reliable way.

Function principle

The principle of UHF magnetic flap level gauge lies in the float Chamber which connected to the tank, and following the law of Communicating tubes, the level in the float chamber is Equal to the level of tank, The float follows the fluid level and transmits its movements contact-free to the  indication rail mounted on outside,  The float has special magnet, which Rotates the wafers by 180 degree as it passes them;  The result is clearly defined level  indication,     

with the level shown in continuous red strips strongly contrasted to white above, ar increasing levels the color of wafer change from whte to red and vice versa

Technique specification;

 Service condition;

Operating pressure: Max. 64Bar

                     Temperature range: -40~400°C

                     Indication rail: ABS up to 80°C

                     ABS+Aluminum: up to 200°C

                     Aluminum: up to 350°C

                     Gasket: PTEF up to 100°C

                     Clingers: up to 350°C

                     Density. min: 0.35kg/dm3

                     Measure range: Max. 5500mm( one part) >5500mm( multipart)

                   -

                   Process connection;

                      Flange: DN 15~40(1/2- 11/2 ″150#RF)

                      Distance between flange and column: 10mm

                      Welding of thread stud

                       Mounting position: Vertical

                  

                      Vent/ Drain connection: Plug1/2 inch                

                      Pipe size: 57x2mm seamless

                      51x1.5mm welding Butt-welding construction with T pipe

                

                     Pipe & flange material: SS304 316

                     Float materail: SS304 316

                     Flap materail: ABS,ABS+ Aluminum, Aluminum

                     Indication rail material: SS, 304, 316, 304 PTFF, U-PVC, PP

 Successful application:

Oil depot for West airport group in ningxia

Changqing oil field for petrochina

East Boiler factory

1) Close drainage valve at bottom, slow open 1B valve, slow open 1A valve, and follow by increase amount of pressure inside the measure tube.

2) The liquid inside the float chamber now moves up to the same level as inside the vessel. When the float passes the wafers they rotate 180 degree from white to red, indicating the exact tank level.

3) The exact level is indicated where the flappers are in a horizontal orientation.

   The level gauge now is ready for operating.

Maintenance:

1) if the clamp contains sediments, Please close 1B,1A , Remove bottom flange, and clean the measure tube. or

2) close 1B,1A valve, open drainage valve at bottom, drain away sediment inside measure tube.

Level measurement & complete set for control system.

The user can according to project requirement, in support to magnetic level gauge application, or selecting local read, or 4~20mA standard signal output, to cooperate with record meter, and also bring out function of alarm control with magnet switch,

4~20mA standard signal output

Record meter

Local read

local read magnetic flap level gauge